Common faults and treatment methods of SPC floor extrusion production line

Time:2021-06-24

Common faults and treatment methods of SPC floor extrusion production line

(1) If it occurs in the reducer, it may be caused by bearing damage or poor lubrication, gear wear, improper installation and adjustment or poor meshing. It can be solved by changing bearings, improving lubrication, changing gears or adjusting gear engagement.

(2) If the noise is a sharp scraping sound, the possibility of scraping between the shaft head and the gearbox shaft sleeve caused by the deviation of the spring box position should be considered. It can be solved by adjusting the barrel.

(3) If the barrel makes a sound, the screw may bend and sweep through the hole, or the setting temperature is too low, which may cause excessive friction of solid particles. It can be processed by straightening the screw or increasing the set temperature.

Leave a Message

If you have any questions, please leave us a message and we will reply to you as soon as possible